Council Offices
The Project entailed the fit-out of an existing Council owned 4 Floor Office Building including demolition, Basement Car Park works, new Sub Mains, Switch Boards, General Light & Power completed late 2015.

Overall the works were completed on time with all of the clients requirements met.

The scope of works consisted of the following –

Communications

450 x Category 6 ADC Krone field outlets

Multiple OM3 Fibre & Category 6 tie cables
Building & Installation of 4 new Communications Rooms 47 RU equipment cabinets.
Voice backbone cabling.
Power/Lighting

Disconnect and make safe of power.
Install soft-wiring and Category 6 cabling for workstations.
Installation of new lighting zones
Supply and Installation of feature lighting in reception, boardrooms and meeting rooms
Supply and Installation of Dynalite control and interface
Supply and Installation of multiple floor-boxes
New switchboards & sub mains to accommodate RCD circuit breakers in accordance with Australian Standards.
The full Dynalite lighting control system was designed and installed to operate all lighting throughout the offices. This system is controlled through time control, motion detection and PE cell operation. The system consists of networks linked via an Ethernet backbone to a computer housed in the Communications room.
Building floor plans and site plans have been used to generate a graphical representation of the office and provide accurate, real-time status of lighting levels.

Product Detail Image
Product Detail Image

Get In Touch With Us





(*) Required Field

Locate Us